Hori Fighting Commander 4 - Microswitches D-PAD Kit

Get microswitches rather than the membrane contacts for the D-PAD of the Hori Fighting Commander 4.

THIS KIT IS ONLY COMPATIBLE WITH THE ORIGINAL HORI FIGHTING COMMANDER 4 (see picture):

Note: You'd need to keep the "red" holder parts with it screw, as long as the original cross to assemble the kit:

Note 2: you can add a dab of silicon grease (like shin-etsu) on the shaft/support of the Dpad to avoid plastic wear.

Video:

Links:

How to Assemble your kit:

You need first to salvage the cross and the red holder (with its screws, not on the picture) from the old D-Pad

Place the PCB on the support piece

Then put the cross on the top

Then put the cross holder on the top.

Put the red holder in place.

From here make sure the cross is correctly working and not scrape any side inside, especially on the UP direction.

Screw each 4 screws on the back, always check if the cross is still working

Done! Plug it on the same ribon cable inside your FC4 and test it!

Qty

Write a review