Hori Fighting Commander 4 - Microswitches D-PAD Kit
Get microswitches rather than the membrane contacts for the D-PAD of the Hori Fighting Commander 4.
THIS KIT IS ONLY COMPATIBLE WITH THE ORIGINAL HORI FIGHTING COMMANDER 4 (see picture):
Note: You'd need to keep the "red" holder parts with it screw, as long as the original cross to assemble the kit:
Note 2: you can add a dab of silicon grease (like shin-etsu) on the shaft/support of the Dpad to avoid plastic wear.
Video:
Links:
https://github.com/TRP-Retromods/Hori-Fighting-Commander-4-D-Pad-Replacement
https://www.printables.com/model/163826-hori-fighting-commander-4-dpad-replacement
How to Assemble your kit: |
You need first to salvage the cross and the red holder (with its screws, not on the picture) from the old D-Pad |
Place the PCB on the support piece |
Then put the cross on the top |
Then put the cross holder on the top. |
Put the red holder in place. From here make sure the cross is correctly working and not scrape any side inside, especially on the UP direction. Screw each 4 screws on the back, always check if the cross is still working Done! Plug it on the same ribon cable inside your FC4 and test it! |
Hori Fighting Commander 4 - Microswitches D-PAD Kit
- Product Code: HORI_FC4_DPAD
- Availability: Out Of Stock
-
USD $15.00
- Ex Tax: USD $15.00
Tags: HORI_FC4_DPAD